SipaBoards are made from extremely durable double-layered PVC material. The top and the bottom layers are held together by thousands of polyester filaments (Drop Stitch technology), making the board rock-hard with completely flat surfaces when inflated, while easily folding into a backpack when deflated.

*values vary according to model


  • Length: 11 feet (3.35 m)
  • Width: 31 inches (80 cm)
  • Thickness: 5.5 inches (14 cm)


  • Length: approx 3 feet (100 cm)
  • Width: 1.5 feet (50 cm)
  • Thickness: 1 foot (30 cm)


  • Board 21.5 lbs (9.75 kg)
  • SipaDrive 8.5 lbs (3.85 kg)
  • Paddle with remote 26 ounces (0.75 kg)


The SipaDrive’s housing is made of high-quality durable plastic, and the drive fits snugly into the slot in the middle of the board. No extra parts are required, as it is held in place by the pressure of the board itself. The top has a sleek-fitting cover, and the bottom intake hole is protected by mesh, so no fingers, fish, or other debris get into the propeller. The electric motor in the SipaDrive is brushless and high-efficiency, as well as emission-free. Its 5 settings will give you up to around 3.5 knots of assistance.

Propulsion and inflation unit specs

  • max. power output while cruising 160 watts
  • max. power output while inflating 250 watts
  • 3 speed settings up to 3.5 knots
  • inflation pressure typical 1  bar/15 psi, max 1,2 bar/18 psi
  • inflation time cca 5 min
  • self-regulating pressure gauge
  • thermostat to prevent over-heating
  • all electronics are tightly integrated and sealed
  • corrosion and condensation resistant parts & materials
  • low and safe voltage levels
  • Bluetooth 4,0 connectivty

Battery pack specs

  • easy to swap out battery pack
  • around 90 minute charging time
  • up to 1,000 battery charge cycles
  • cca 3 hours of operation at cruising speed

Housing dimensions

  • Length: 20 in (52 cm)
  • Width: 8 in (21 cm)
  • Thickness: 5.5 (14 cm)


The SipaPaddle has a lightweight carbon-fiber shaft and fiberglass blade. The SipaDrive remote is attached to the shaft and it communicates with the motor via wireless connection. This communication is interrupted immediately whenever the paddle falls in the water, or whenever it is separated from the motor by more than a few feet, making sure you never get separated from your SipaBoard.

Remote control

  • rechargeable battery for 10 days of active use (only in use when SipaDrive is engaged, shuts down automatically when not in use)
  •  on/off button and three buttons for increasing/decreasing speed
  • audio confirmation of control and error notification
  • easy use
  • auto shut off