Never pump your paddleboard again!
Pumped up and ready to go!
Pumped up and
ready to go!
Because everyone likes to paddle - but no one wants to inflate the board.
Small feature, big difference.
No add-ons, no cables, no pumps and no hoses. Seamlessly integrated into the board's fin-box and always ready to take on the strenuous work so you don't have to.
Always just right
Using our proprietary solution and built-in sensors, every Sipaboard is always inflated to the desired pressure. Automatically, without a sweat. It sounds simple - because it truly is. Plug in, inflate your Sipaboard, hit the water.
Explore Air products
We're a different global tribe.
We're a different type of crew.
Previous
Next
Paddling into the e-future
Paddling into the e-future
Sipaboards, the watersports revolution.
Techonology meets sports and leisure: our products bring comfort, joy and safety to your favorite paddleboard trips and enable you to explore new waters.
You’ve got questions?
We’re here to help!
The compressor will inflate the boards in 5 to 7 minutes, depending on the boards volume. It is capable to inflating the boards to 15 PSI (1 bar). If the pressure drops, you can always use the compressor to re-pressurise it to the pre-programmed pressure.
Yes, the battery capacity is below the 150Wh, so the compressor is cleared to fly under IATA guidelines. It is however always advisable to check with your air carrier if there are any restrictions regarding travelling with electronics and batteries. All SipaBoards systems are manufactured using fire retardant materials, making them as safe as possible for aircraft travelling.
Yes, the system has a standard air-vent that can be connected to the hose for infating other boards. With the app, you can even regulate the pressure to accomodate other inflatables’ internal pressure requirements. Bear in mind that each inflation cycle will discharge the battery and cause the compressor to heat up so it is advisable to take time between inflation cycles in to not overheat the unit.
The compressor will inflate the board from completely deflated to optimal pressure up to three times. After that, the charger will fill the battery in 2 hours.
When the compressor is inserted into the board, you should first hear a click, as the plastic clasp locks the unit. After that, remove the unscrew the blac cap of the air vent and press it gently onto the plastic bump on the right side of the compressor’s surface. The magnetic switch under the bump will turn the compressor on and start the inflation cycle.
No worries, we’re here to help. You can write to us into the chat on the left side of the website, or reach out directly to us on info[@]sipaboards.com. If you wish to reach us by phone, we are available on +386 41 628 497.
